1、Q:您好,部分同学想要测试Bluetooth硬件,但是不知道如果按照Bluetooth SIG需要测试什么项目? A:请看截图 2、Q:产品只用到BLE的模组,需要测试这么多测试项? A:当然不需要,根据《RF-PHY.TS.4.2.2》普通条件下(NOC:normal operating conditions)BLE-RF-PHY需要测试的项目如下: TP/TRM-LE/CA/BV-01-C [Output power] TP/TRM-LE/CA/BV-03-C [In-band emissions] TP/TRM-LE/CA/BV-05-C [Modulation Characteristics] TP/TRM-LE/CA/BV-06-C [Carrier frequency offset and drift] TP/RCV-LE/CA/BV-01-C [Receiver sensitivity] TP/RCV-LE/CA/BV-03-C [C/I and Receiver Selectivity Performance] TP/RCV-LE/CA/BV-04-C [Blocking Performance] TP/RCV-LE/CA/BV-05-C [Intermodulation Performance] TP/RCV-LE/CA/BV-06-C [Maximum input signal level] TP/RCV-LE/CA/BV-07-C [PER Report Integrity] 3、Q:还是有这么多测试项?我们精力和实验条件有限啊,能划去几条嘛? A:应该可以减少几个干扰测试: TP/TRM-LE/CA/BV-01-C [Output power] TP/TRM-LE/CA/BV-03-C [In-band emissions] TP/TRM-LE/CA/BV-05-C [Modulation Characteristics] TP/TRM-LE/CA/BV-06-C [Carrier frequency offset and drift] TP/RCV-LE/CA/BV-01-C [Receiver sensitivity] TP/RCV-LE/CA/BV-06-C [Maximum input signal level] TP/RCV-LE/CA/BV-07-C [PER Report Integrity] 4、Q:请问有该测试的相关指令或者资料参考一下吗? A:有啊,请点击链接,【蓝牙Mesh】精品系列之二——RF-PHY-Test of BLE Q:b( ̄▽ ̄)d ,我们回去研究一下哈,
|