wpa_cli 连接 wifi

Wi-Fi_001

wpa_cli 连接 wifi
1: run wpa_supplicant first

use the following command:
wpa_supplicant -Dwext -iwlan0 -C/data/system/wpa_supplicant -c/data/misc/wifi/wpa_supplicant.conf

2: Run the command line tool wpa_cli to connect wifi

wpa_cli -p/data/system/wpa_supplicant -iwlan0
Then , it will let you set network interactively

some common command:
>scan = to scan the neighboring AP
>scan_results = show the scan results
>status = check out the current connection information
>terminate = terminate wpa_supplicant
>quit = exit wpa_cli
>add_network = it will return a network id to you
>set_network <network id> <variable> <value> = set network variables (shows list of variables when run without arguments), success will return OK, or will return Fail
>select_network <network id> = select a network (disable others)
>disable_network <network id> = disable a network
>enable_network <network id> = enable a network
> set_network 0 priority 0
> list_network
> save_config

3: example
for AP that doesn`t have encryption
>add_network      (It will display a network id for you, assume it returns 0)
>set_network 0 ssid “666”
>set_network 0 key_mgmt NONE
>enable_network 0
>quit

if normal, we have connectted to the AP “666”, now you need a IP to access internet, for example:
dhcpcd wlan0
if everything is ok, it will get an IP & can access internet

for AP that has WEP
>add_network      (assume returns 1)
>set_network 1 ssid “666”
>set_network 1 key_mgmt NONE
>set_network 1 wep_key0 “your ap passwork”(if usting ASCII, it need double quotation marks, if using hex, then don`t need the double quotation marks)
>set_network 1 wep_tx_keyidx 0
>select_network 1  (optional, remember, if you are connecting with another AP, you should select it to disable the another)
>enable_network 1
and then ,get an IP to access internet

for AP that has WPA-PSK/WPA2-PSK
>add_network      (assume returns 2)
>set_network 2 ssid “666”
>set_network 2 psk “your pre-shared key”
>select_network 2  (optional, remember, if you are connecting with another AP, you should select it to disable the another)
>enable_network 2

there is still some others options to be set, but wpa_supplicant will choose the default for you, the default will include all we need to set and then ,get an IP to access internet

命令执行后，wpa_cli 会输出连接的过程信息。如果一切正确，则最后后输出：
<2>CTRL-EVENT-CONNECTED - Connection to xx:xx:xx:xx:xx:xx completed (reauth) [id=0 id_str=]

获取IP地址
用 quit
命令退出wpa_cli 。然后用
dhclient wlan0
命令获取IP地址。